If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?
- 10 Answers
- 13159 Views
- QAFCO, I also Faced
- E-Mail Answers
Answer Posted / kp
10 kg
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
What is three element in drum level?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
why fuse block is not used for AI signal?
Why trim span ? How?
Meaning of the following a. IOP- Manimum; b. IOP- Maximu,;
How to Calibrate Flow Switch in field
Explain the key components of control loop?
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
How to fix back the valve actuator stem
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is stripper & spilitter ? Diffrence in this.?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
What is the PLC configuration in Cement industry?
