Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the effect of leading power factor on
turbogenerator (and system) that is running parallel with
other TG.
- 1 Answers
- 3710 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
iT IMPROVES POWER FACTOR AND STABILTY OF GRID BUT GENERATOR
ROTOR INSULATION IS OVERHEATED,LIFE IS REDUCED.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
What are the two segments of nyquist contour.
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
How to calculate the multiplying factor for energy meter with ct ratio given
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
What is phase cross over frequency?
How could a garment factory benefit from renewable energy
how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
What is depreciation factor?
what is meaning of 230volts ac 50hzs ac supply is it rms or maximum to getting ac 230v what amount of max voltage they will send
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
