Interested to Buy Any Domain ? << Click Here >> for more details...
Why the ceiling fan rotates in clockwise direction and table
fan rotates in anticlockwise direction.
- 3 Answers
- 9660 Views
- Kirloskar, MPF, Wipro, I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
there is no different for the fan,whether itis clockwise or
anticlockwise for table and ceilinf fans. it is just the
design of fan blades.
But it matter for the exhaust fans.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
draw 3 phase rectifier diagram
What do you mean by passive circuit elements and why these are called passive?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
wow to calculate the transformer rating(KVA)
what is harmonics? what are the factors it will depend upon
How to Calculate The sag of OPGW in Transmission Line???
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
11 kV line deraction check by an Engineer.
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Which is the oldest hydropower plant in india?
why ss stablity limit is more transient stablity limit?
Why you want to join non technical field when you are an engineer?
