High Voltage out door substation-annual maintenance, things
to be considered
- 1 Answers
- 3343 Views
- I also Faced
- E-Mail Answers
Answer Posted / a.p.nanjappa
1) BOLT CONNECTION ALL EQUIMENTS CHECKING.
2) MAIN EARTH CONNECTION.
3) eARTH SHIELD, fiber optic cable connections.
4) Test the CB TIMING ,INSULATION, PROTECTION RELAYS,
ct,VT, - OIL TESTS, DS,ES,
5)hvac
6) DC system
7) Outdoor lighting/emergency change over.
8) On line sub stn cleaning eauipment
9) funtional test for Bus bar differenctial protection and
its logic sequence restoration of sub stn equipment. if any)
in case of one and half CB sub-station configuration.
10) fire fighting system.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Write a note on materials used as a fuse element.
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
tell me some type of questions throught which i can prepare for exam and do my best
dear all i am kumara now current working in electrical designing of control and relay panel i want learn some substaion design then any book are available. pls mention name and authour
What are motor generator sets and explain the different ways the motor generator set can be used ?
what kvrah y we need to take the readind of that
how dose servo motor works
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
What are the difference between normal application Transformer and Solar application Transformer?
What are the protections for safe running of electric generator?
Please brief working principle & construction of permanent magnet AC Servo motor
why occ characteristics curve in not tracing back when we are bringing back the rhoestat?
How DC earth leakage currents can be reduced ?
How would you calculate power loss in a resistor?
