Interested to Buy Any Domain ? << Click Here >> for more details...
what should we do when the CT secodary gets open? how do we
short circuit it? using tester or screw driver? not
dangerous?
- 6 Answers
- 9990 Views
- I also Faced
- E-Mail Answers
Answer Posted / kashif saeed
it is danger to short the CT with screw driver or tester, it
is better to take the shutdown and than short the CT with
the tester or screw driver.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what are the things that can cause a three phase motor to crawl?
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
What do you mean by turns ratio of instrument transformer?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
11 kV line deraction check by an Engineer.
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
Can we use Ccapacitive voltage transformer directly for metering purpose?
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
What is the physical significant of power factor?
how tto ingress mw in turbine explain.procedure ?
how can we select the appropriate VCB ?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
What is the formula to calculate the no load current of a single & three phase induction motor
what is the isolation transformer. what is the isolator?
