Interested to Buy Any Domain ? << Click Here >> for more details...
how to replace 8mm bar with 10mm bar if the the 8mm bar is not available..???
- 3 Answers
- 47463 Views
- CICEF, I also Faced
- E-Mail Answers
Answer Posted / mustafa mohammed layeak
Area of 8mm dia bar = 50.28 sqmm .
Area of 10mm dia bar= 78.57 sqmm .
For example if you don't have 8mm dia bar available to use
in 1m strip of slab,then one can use 10mm dia bar with an
increased spacing relative to 8mm dia bar.And reqired area
of steel in 1m wide strip is 452 sqmm/m length (Ast/m
length). the calculation is as follows
Using 8mm dia bar we get spacing in 1m wide strip as
s=[(b*Abar)/Ast] therefore s=[(1000*50.28)/452]. Therefore
required spacing with 8mm dia bars= 111 mm c/c.
similarly the required spacing using 10mm dia bars will be
spacing = [(1000*78.57)/452]. Therefore required spacing
using 10mm dia bars = 173mm c/c in 1m wide strip length.
| Is This Answer Correct ? | 63 Yes | 9 No |
Post New Answer View All Answers
How to calculate canal slope curvature qty!
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
Dear sir, i want to NBCC & NTPC previous exam papers email Id : madhu_bingi@yahoo.co.in
how clculate excavated or backfilling quantity by simpson's rule
hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft
How much material will consume for following specification water tank (9*7.5*6 feet)?
what is right & short method of measurement of slab&beam
List out some of the software used in the construction sector to estimate cost and monitoring expenses?
How to calculate steel for beam slab and column
What is the standard volume of pharma in cub ft
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
As we know that steel is a tension member but why we are using STRUCTURE STEEL as a COLUMN (Without concrete) where column is a compression member and compression strength of steel is very low
In jack arch floor, the rise is kept?
i just want to know how much require sand and cement for 1 sq.mt including wastage. Please guide me as soon as possible.
What is the use of extruded feature in solidsworks?
