Interested to Buy Any Domain ? << Click Here >> for more details...
can install leveltrol in steam drum for measurment the level
of steam drum? if not then why?
- 1 Answers
- 8912 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh
no we cannot install level control element since \=
for low demand there is swell effect
for high demand there is shrink effect
thus the reading shown by level tx will be not exact
we use computational algorthm for level ctrl
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
How d.p. Transmitter can be applied to close tank?
In Safe Guarding test what means by "Failed to Danger" ?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
What is the differerence between hysterisis and linearity.
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
What are the type of bonnets in the control valves?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
plz send me general of ongc
What are different types of cable?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
What is the use of GMV in turbine?
