if we put any thermocouple on a table in a room without any
connection,what temperature should it show.

Answer Posted / siva

what the room temperature maintained thats it showing..

Is This Answer Correct ?    6 Yes 9 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

why we take %i0.0 as input for twido plc

1765


what is SIL 1 2 3

1643


How will you test a transistor with a multimeter?

714


what is the process for double acting cylinder pneumatic for 32' v/v

1724


it is possible to check the fail safe condition in pressure transmitter. if possible how?

983






Any one can help me to identified, how can we interchange the device in FF

2403


A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.

1797


when a magnet is heated?

1625


key exchanges in wpa,wpa2,tls

1600


Galvanizing.

1550


what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other

1796


what is difference between HOT permit and cold permit

1710


our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS

1755


How ejector(or)evactor air pump is working in thermal power plant?

6185


what is the reason while warning lamp is on while the engine is cranking?

1709