Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / p_mehboobkhan
better opportunity
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Differentiate between induced emf and self inductance?
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
How to know vacuum in vacuum cylinder of breaker in working condition
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
How is the gain affected by the introduction of feedback in a control system.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
Why single phase induction motors are not self starting ?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
what is the id1 & id2 setting in differential protection relay of CSPC?
why constant voltage transformer should be start without load? and if started then what will happen?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
how is the magnetic current test is different in delta-star and delta delta transformer.
How would you calculate power loss in a resistor?
What are the function of different components of servo motor?
