Interested to Buy Any Domain ? << Click Here >> for more details...
what is the output of conductivity sensor and PH sensor?
- 3 Answers
- 7870 Views
- I also Faced
- E-Mail Answers
Answer Posted / naveed iqbal sher
PH sensor output is mv
conductivity sensor output is a current.(milli amp or micro
amp)
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
IN CONTROL VALVE SPECIFICATIONS GENERALLY TERM " DE- 200" ."DM -400"USED,, WHAT IS DE/ DM STANDS FOR?
How can you add value to this Industry if offered the job?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
what is the procedure of belt scale calibration?
How to calculate mmwc values into tonnes?
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
How to control flow variations in magnetic flow maters..... When i will provide proper earthing?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
which processor is used in dcs.
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
What is hp & mp seperator .& what is its working principle ?
