What is subnetting and supernetting and its uses?
Answer Posted / jitendera
Ok Pandi
I have one question for you and all of you guys
if Subneting is something like breaking a Single block of ip
in the multiple block of ip address and Suppernating is
combining the Multiple ip block in to single block am i wrong ?
Now the Question is that
i am using a Routing protocol say eigrp
and i am configuring like
router eigrp 100
network 10.10.10.0 0.0.0.0.255
network 10.10.20.0 0.0.0.0.255
network 10.10.30.0 0.0.0.0.255
now if i make the command
show ip route
it will show
10.0.0.0/16 has been thorugh EIGRP and there will no entry
of 10.10.20.0 and 10.10.30.0
1) So what i have to do so that the all three subnet show
in routing table-- quite simple think and answer
2) if you get the answer then tell me at last what is the
difference between Subnating and suppernating
Think like genius not like me :-)
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How network gateway is different from routers?
What is the icmp protocol?
What are the different memories that are used in a cisco router?
Why ip address called logical address?
What is quality of ipv6?
When does network congestion occur?
Tell me how much hold down time of eigrep protocol?
Define the multicast routing?
In port based access-list which command u give instead of ip?
In stead of 0.0.0.0 wild card mask what you can write after ip?
Explian what is a node?
What is default packet size of ipv6?
Which type of transmission bus topology support?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What does vlan provide?