Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use less dia. fuse and conductors at H.T. side, although we use higher dia. cables on L.t. side?
- 4 Answers
- 8111 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / shri..
In HT line Voltage is high & current is low
In LT Line Voltage is Low & current is high.
If we take a example of Stape down Transformer
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
explain the function of brush less dc motor?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
what parameters should we check to reduce the power bill
TELL ME WHAT IS INDUCTOR AND CAPACITOR WHAT IS IT BASIC OPERATION ANDFUNCTION?
why we can stote dc? why we cant store ac?
What are the advantages and disadvantages of short-pitched winding?
What is Auto Mains Failure Panel & Auto Synchronizing Panel
how will we calculate the copper wire load..
why transformer tank is in rectangular shape what happen when it is in step shape
why normally Generator rating are between 11Kv to 22Kv?
Define peak time.
Iin ESP why positive is grounded ? why not negative ?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
