Why we use less dia. fuse and conductors at H.T. side, although we use higher dia. cables on L.t. side?
- 4 Answers
- 6387 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / electrical alie
Go to a university that has an electrical engineering
curriculum an you will see the light.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is the difference between elcb and rccb ?
specific difference of ICT&Auto Transformer
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
raleigh method
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
Tell me about ur past electrical maintanence job
how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .
how to flameproof electrical motor on the shaft?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What is the drawback of class b amplifier? How is this minimized?
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
if voltage bt phase & nutral is 38v in a panel board . whats the root cause.
What are the advantages of autotransformer?
