Answer Posted / ali raza
220v/50 Hz is economic as thin conductor is required
usually pakistan and india use this as it is a British standard however it is more dangerous than 120v/60 Hz which is american standard and expensive as thick conductor is required
by ali raza electrical engineer(power)lahore pakistan
| Is This Answer Correct ? | 16 Yes | 2 No |
Post New Answer View All Answers
Define noise?
why swinburnes test cannot be performed on series machines?explain
how to prepare the technical test
What is a slack bus?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Why we are use dol starter up to 10 hp
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
a simple c++ program to calculate simple interst with its data members as private
State thevenin’s theorem?
What are stable systems?
What is the working principle of servo motor? And explain it.
how to test the electrical panel.ht lt mcc pcc.
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
