Interested to Buy Any Domain ? << Click Here >> for more details...
What is min and max voltage between earth and neutral/phase
if it perfect earthing?
- 37 Answers
- 258443 Views
- Epoch, ISS, ITC Infotech, L&T, Power Works, Statex, Sterlite, Wipro, I also Faced
- E-Mail Answers
Answer Posted / chandrakant rewatkar
min voltage is Zero ( if no joints)
max voltage is 3 volt ( if there is the joints)
if these value get in case of 3phase supply with P and N
if supply voltage is 415 without variation in voltage.
if value is more than 3 volts,
then load is unbalanced
Earthing not perfect
neutral not proper from incoming supply
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
how to calculate transformer turn primary & secondary side 11kv to 420v
what are all types of cross section in AC cables?
USE OF 8 WAY PAN ASSEMBLY
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
what is ic 01,ic 06 ?is it types of cooling?
what is the differance between HT motors And LT MOTORS.
Why earthing is necessary for any equipment?
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
Inductor and capacitor........power in one phase and ...... in it another phase.
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
What is the difference between cylindrical-type and sandwich-type winding?
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
