Answer Posted / karthi
tranformer has no rotating part like rotor and stator..and
no torque produced in it..so transformer is static device..
| Is This Answer Correct ? | 20 Yes | 3 No |
Post New Answer View All Answers
what are the things that can cause a three phase motor to crawl?
What is the difference between grid and off- grid system??
List the advantages of star-delta starter with induction motor?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
What is installed in PAC that is control the humidity
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
wish of these transformer uses oil?
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
what is lumped and distributed elements?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
please send me previous year questions of jspl through which i could prepare myself for the test.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What type of DC motor would you see for a lift?
Define phase cross over?
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
