What motor is used in ceiling fans and what motor is used
in table fan.? why table fan is costlier than ceiling fan?
- 6 Answers
- 26547 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / jyothis prasad t
Single phase induction motor is used in ceiling fan,that's
why a capacitor provide for it to get the starting torque.
Refer two field revolving theory for reference.i don't sure
about table fan i think the previous answer is correct ie.
universal motor.
| Is This Answer Correct ? | 5 Yes | 15 No |
Post New Answer View All Answers
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
What is inverse definite minimum time lag relay? Where is it use?
What is inductance?
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is accuracy of a measurement?
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
why we use copper earthing for neutral while for body GI.
What is MS-EXCELL?
what is circuit recombiner and how it is different from circuit breaker
What is grid collapse? what is the reason for it?
how to find the Motor,s insulation Power?
Mention the disadvantages of low power factor? How can it be improved?
Difference between megger test equipment and contact resistance meter test instruments?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
