Interested to Buy Any Domain ? << Click Here >> for more details...
What are all the points to be checked for a newly re-winded
motor before installation
- 1 Answers
- 4363 Views
- Cisco, I also Faced
- E-Mail Answers
Answer Posted / anurag pattanayak
1)check megger value..phase to phase and phase to ground
2) check phase resistance and inductance
3) check phase continuity
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Why colled 440V to 3-phase supply.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
What conditions are required for transformer to operate at low frequencies ?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
what is cathodic protaction?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
how much cable size required for 70 kilowatt load.
pre arcing time of ehv breaker
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
Explain Energy and Power signals?
How to see the inductance in a transmission lines
How you calculate the repturing capacity of a HRC fuse
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
