What motor is used in ceiling fans and what motor is used
in table fan.? why table fan is costlier than ceiling fan?
Answer Posted / l.raghuraman15
still searching for the answer. my friends told that
universal motor is used in table fan which can operate on
both AC and DC current, whereas in ceiling fan induction
motor is used which can operate only in dc current.
Is This Answer Correct ? | 6 Yes | 51 No |
Post New Answer View All Answers
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
what is diff. between earthing grid,earthing mess, earting grid?
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
what is the difference between directional & non directional earth fault with example please explain.
how point on wave controller works.
what is the use of expulsition protective gap in 11Kv line.
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
can we conduct the swineburne's test on a dc series motor? why?
hi can anyone pls tell me the eee interview core questions asked in l&t
How much ph is maintained of water resistance starter for slipring induction motor ?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??