Interested to Buy Any Domain ? << Click Here >> for more details...
we have LPG spherical Tank and we want to install DP Xmtr
for level measurement.below are the physical measurements
Total height of tank is 1850 mtr but 0% level is 1000mm
above bottom and 100% level is 450 below upper side.What is
the LRV and URV and please mention the formula .The SG of
LPG is 0.53 and Wet Leg method will be used.
- 7 Answers
- 12157 Views
- I also Faced
- E-Mail Answers
Answer Posted / imran
Mr Ghalib Its 450mm below upper side.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
What are the types of control valves available
Explain an adaptive / self-tuning controller’s major draw card.
for oil & gas industries which zone is normally preferred? why? give its example?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
1.what is the effect of vapour presuure in orifice plate flow measurement 2.which is more effective 2 pressure sensors or one single differential pressure sensor in orifice plate measurement 3.how to design a v/i converter and i/v converter 4.how many type of thermocouple are there 5.how many leads are there in thermocouple measurement 6.how pressure sensors are connected in level measurement in differential pressure method 7.what is the output of capacitive pressure sensor (ac or dc),how its o/p is signal charactarized 8.what is the physical meaning of discharge coeeficient,why it is calculated,orifice plate what is its value,why it is less than 1,Q at upstream is equal to or not equal to Q at downstream of orifice plate why?what is vena contracta in orifice plate 9.why rotameter is called variable area flowmeter,it can measure flow even if area is not varying,why it is made tapered 10.design a 10 bit counter ,which counter you will prefer 11.how to remove self heating error in RTD 12.which is more sensitive pt100 or pt50 13.why thermocouple are connected in parallel 14.what is lead contact error in RTD,how to avoid 15.what is P,PI,PID,PD controller,why there is no ID controller 16.what is override,split range,sequential,ratio,feedforward,cascade controller 17.why we moved from SR to JK and then JK to master slave JK flipflop,give correct reason 18.how to measure level of a closed container which contains vapour and liquid,remember no vapour gas should be leaked,so ultrasonic and capacitive is not an option,design another method 19.how to design horse race counter including sensors and signal conditioning element 20.what is bevelling
What is the difference between ff transmitter and non ff transmitter
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
what is maxdna ?. explain about the software details.
Explain Gas Turbine startup and shutdown sequences
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
If fire would be inside the plant which fire detector is to detected the fire.
