Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning of the HT LT transformer?
- 10 Answers
- 76468 Views
- Sify, I also Faced
- E-Mail Answers
Answer Posted / eeman
HT stands for High temperature and LT stands for low
temperature. How come HT and LT means High voltage and low
voltage respectively.
| Is This Answer Correct ? | 31 Yes | 38 No |
Post New Answer View All Answers
If increased the frequency up to 1000 then what changes shows in voltage?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
how many load we can take for lighting
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
what are the different kind of cables used for transmissions?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
operation of diesel generator
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
Why reactive power is needed in a power system? How is it being absorbed or delivered by alternators? For reactive power control we are changing excitation but reactive power absorbing or delivering related to stator. How these two are interlinked? i want a detailed explanation with necessary expressions and figures?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
