what would the resistance of a 110v 150w submersiblepump
motor windings be
- 1 Answers
- 3887 Views
- I also Faced
- E-Mail Answers
Answer Posted / arunraj
power=VI
VI=150 => (110)*I=150 => I=1.36Amps
R=V/I => R=(110)/(1.36) => R=80 ohms.
Resistance is 80 ohms.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
how slip power recovery system work
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
what is the difference between Power and Distribution transformers ?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is PEC??Applications........
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
What is the difference between solid grounding and impedance grounding?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
Why the arms of delta in a delta-wye power transmission system are kept constant??
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
defination of controlled shunt reactor
Parts of machine and their discription in details with suitable photo
distribution is maximum done by a)radial b)network c) parallel d)b & c
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
