Interested to Buy Any Domain ? << Click Here >> for more details...
if earthing is not connected to computers any
problem ?
- 2 Answers
- 7457 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / subrahmanyam
computers are working on low voltage (after SMPS) if high
currents are coming from, the supply source the high
currents will be discharged through the earthing. if you
are not providing earthing those high currents where will
go. your mother boards and other components may get damaged.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
WHY CBCT USE ONLY IN Y PHASE NOT OTHER PHASES
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is the pro & con of having 11kv & 33kv incoming, and what is the adv & disadv. of converting from 11kv to 33kv.
If a high resistance fault occurs,then what are the changes will happen in the system?
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
What do you mean by the zone of protection?
State and define ohm’s law?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
what is interpose? where it is used and why it is used?
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
how maney type tempereture measurement ?
Merits & Demarits of Oil circuit & Air circuit breakers ?
