Answer Posted / raju kumar singh
Auxiliary relay is a relay which will repeat the operations of protective relay such as tripping, time lag, breaking of trip circuit current, giving alarms and showing flags etc..
Protective relay contacts are delicate and light weight hence it will not capable of carrying a large amount of current for a long period.
protective relays do not have enough contacts to perform all the operations of protective scheme.
Therefore auxiliary relays, auxiliary switches and repeat contacts are used to assist protective relays.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
As i want some model question paper in basic computer science and history please send me immediately sir
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
direction of tarbine& genrator
Installation method of self treated earth electrode.
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
What is meant by short-pitched winding?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
How servo stabilizer works.
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
in 132kv substation CRT means
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
In siemens PLC, why do we want to move the data ?
