Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / s.sakthivel
(1)to not start with load
(2)to not start immediate start and stop and start stop function
(3)not start condition to check the all parameters as per engine requirements
(4) to maintain battery nominal voltage
(s.sakthivel -perambalur)
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
how calculate gd2 of ht motors
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
What is a system?
What are the advantages of hydropower?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
why does rotor rotets?
What happen Grid EARTH plat got cut.
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
sir vizag steel ka junior trainee ka paper kitne number ka ayega
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
in dc shunt motor if field winding is shorted then
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
