Interested to Buy Any Domain ? << Click Here >> for more details...
A temperature sensor (RTD) connected via a temperature transmitter is adjusted to give an output of 4ma at 60 deg and 20 ma at 600 deg.
This output (4-20ma) from the transmitter is connected to an IGBT-inverter to control a high speed (-12,000 to +12,000 RPM) DC motor.
And in the inverter it is programmed as, for 4ma the motor speed will be -3,000 RPM and for 20ma the motor speed will be +10,000 RPM.
The question is : If the motor speed is +5,500 (RPM), what will be the temperature?
(-sign indicates that the motion is in reverse direction).
- 9 Answers
- 10450 Views
- I also Faced
- E-Mail Answers
Answer Posted / kusito
Temperature = 109.5 deg; output = 7.3 mA9
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Valve positioner and actuators in detail.
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
What is the use of temperature compensation?
why we r opening HOT BYPASS valve during startup of a compressor?
How to calibrate capillary type level transmitter
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
How many types of sensor
how to check earthing,what is minum ohms for proper earthing
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
How many interlocks at turbine? Plz explain briefly
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
