Interested to Buy Any Domain ? << Click Here >> for more details...
I have a 25 KVar capacitor bank at my facility.How to check
the capacitor bank ??
- 2 Answers
- 14693 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
calculate the amperage the bank requires and use a clip on
amp meter to check it out.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is the source of dependent source ?
What are the advantages of stationary armature and rotating field system?
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
What are reasond for high wattage in single phase induction motors
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
What are the relays in ACB and VCB
what is transient enclosure vltage , very fast transients, very fast transient over voltages
how to calculation increase power factor for single phase
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Which Class insulation is prefered for the sandwich Busducts ? Why?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
what is the main difference between power devices and signal devices
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
