Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / manoj
C.T is used for mearusng very high current,d C.T lower down d level of current which we can measure easily
P.T is used measurng very high voltage,d level of voltage is lower down by P.T thn voltage mearusng becom easily..
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
distribution transformer de-rating formula on over limit iron losses
what is physical distance of isolator to VCB in 33/11kv sub stations
explain Density
Starting Time of LT & HT Motor
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
What is the difference between Generator Differential Relay and Transformer Differential Relay?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
what is the working principle of a DG Set, Alternator, & exiter
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is mean by drives?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
what is effect of length of air gap on performance of dc motor and generator?
Maintenance of transformer???
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
