Interested to Buy Any Domain ? << Click Here >> for more details...
What is the basic working principle of Tri vector meter?
- 5 Answers
- 31935 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / nirupa chaturvedi
trivector meters are used to measure kVAh and also kVA of
maximum demand.it has a kwh meter and reactive kvah meter in
a case with special summator mounted between them.
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
how to calculate energy of 3-phase motor?
XYZ
what kvrah y we need to take the readind of that
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
how could we calculate the no of outgoings from a 800 watt distribution board
What kind of Neutral CT can be placed in 11/0.433KV transformer to be used and what are its specification?
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
what is the working process of over & under voltage relay.
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
