Interested to Buy Any Domain ? << Click Here >> for more details...
how we calculate fault current& load factor or fault
level&also the leakage current
- 1 Answers
- 4065 Views
- I also Faced
- E-Mail Answers
Answer Posted / wareagle
You go to college and get an electrical engineering degree
and you will know how to do this
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
volts=230 c=10mf a=??
what is the difference between droop mode and ischnorous mode in thermal powerplant?
why we used ZNO in Lightning arrester.
why we can use 1 to 5V dc
what is effect of length of air gap on performance of dc motor and generator?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
what a function diesel generetaor turbo charger & turbo charger is more heated explain reason ?
Transformer how to maintaince a check b check c check d check
how to calculate slip ring induction motor stator and rotor currents??
sir, I am from EEE branch.On feb 17 iam going to write an Exam for hindustan petrolium corporation Ltd.So plz send me the written exam pattern/Q's/interview questions.please mail to eee_dharmendra@yahoo.com
Control cables in S's will carry 1000v which is AC R DC? Pls answer me
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
What is use of starter and choke in tube light
