Interested to Buy Any Domain ? << Click Here >> for more details...
What is C-factor?why it is required to consider in fault
short circuit calculations?
- 2 Answers
- 12597 Views
- I also Faced
- E-Mail Answers
Answer Posted / amirr
please refer to IEC 60909 Standard
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
a simple c++ program to calculate simple interst with its data members as private
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
What are the basic properties of signal flow graph?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
where we use the SFU & FSU?
Mention how NPN and PNP transistor works?
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
What is the effect of pd controller on system performance?
What are m circles?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
why moisture formation found in XLPE Armoured cable outer sheath
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
boiler is running in rankine cycle and deisel generator is....?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
