Interested to Buy Any Domain ? << Click Here >> for more details...
If an Instrument has 550 ohm internal resistance and the
cable used for that instrument is 0.5 ohm per meter
resistance. If the voltage is 12volt.How much length cable
can be used?
- 2 Answers
- 5490 Views
- I also Faced
- E-Mail Answers
Answer Posted / thirus
600 meters
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
How servomotor controls throttle valve of TURBINE?
what is the calibration procedure for transweigh make weigh feeder?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
How it the difference between force balance system and dispalacement balance system?
How to Calibrate Vibration Probe (Axial, Redial) in field
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
How many interlocks at turbine side?
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
Conversions
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
Explain why use mmwc unit?
