Interested to Buy Any Domain ? << Click Here >> for more details...
why indicated sypply only by 440V in 3-phase system.
- 2 Answers
- 5135 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay kumar reddy.c
in a three phase system any time one phase will consist as zero voltage.other phases will be max voltage
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
condition Autotrip facia come on control panel of electrical transmission line?
WTA used cb?
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
difference between high and low impedance BUS BAR relay??
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
WHAT IS VCB SAFETY
What is stacking factor? What is its approximate value?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
how to protect motor in dol starter having capacity of 30 hp.40 hp?
How to set a Zone 1 distance relay for distribution feeder?
why we used dc supply for field in dg set
