we use 3 phase supply for induction motor why not use two
phase supply .
- 4 Answers
- 5934 Views
- TLC, I also Faced
- E-Mail Answers
Answer Posted / wareagle
Because it does not exist.
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
what is the difference between megger and earth resister ??
What are the basic & Majour problems in UPS ?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
What is line resistance of cable & how it can be measured ?
hello if any one have papers vof hpcl or sail, plz send me
in non technical way how can u define POWER FACTOR??
raleigh method
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
how the works electronic energy meter?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
How PSV sizing being done
How would you calculate power loss in a resistor?
