Interested to Buy Any Domain ? << Click Here >> for more details...
how the transmission voltage ranges are decided like
11kV,33kV,66kV,132kV,220kV,400kV,725kV.... why not choose
the transmission line voltage as 23kV,164kV,440kV?? what's
the reason??
- 3 Answers
- 10060 Views
- I also Faced
- E-Mail Answers
Answer Posted / manish sharma
In the case of a sinusoidal wave ie., an analogue wave, the
form factor is approximately 1.11.
Form factor of an alternating current waveform (signal) is
the ratio of the RMS (Root Mean Square) value to the
Absolute Average Value (also referred to as the Practical
Average Value) of the waveform.
Therefore due to form factor our volatges are 11KV, 33KV,
66KV ...
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
What is the Current equation in series RLC circuits.
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is the formula for computing cable tray size & capacity
What is meant by cold loop test in instrument
What is meant by a stray loss of a induction motor??? What is the equation to find it
What is the difference between Generator Differential Relay and Transformer Differential Relay?
wat is the first thing dat is needed, 2 lay a cable in some area??
what is excitation/
which IS or IEC is used for earthing,breakdown voltage of transformer oil, hv/pd testing and all type of electrical testing
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
i want to know about torque of slip ring induction motor
What is use of starter and choke in tube light
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
Why is the air gap between the pole pieces and the armature kept very small?
