Interested to Buy Any Domain ? << Click Here >> for more details...
In a star(primary) to delta(secondary) transformer,how you
take the neutral point?
- 3 Answers
- 6173 Views
- HLL, I also Faced
- E-Mail Answers
Answer Posted / dwivedi sandeepdhar
you can get the neutral point by using voltage grounding
transformer.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
On what principle electric motor works?
How to find out damper winding failure for synchronous machine?
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
What is load boxes ?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
How two nos. 130 kw D.C motor get synchronise using D.C drive.
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
how can we design robots
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
Can a generator runs after getting 1st stator earth fault.
How can we measure the residual voltage in dc machines?
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
Y phase plates are used in transmission line??? what is there need???
