Interested to Buy Any Domain ? << Click Here >> for more details...
tell me the operation of ELCB. How it detects a fault?
- 4 Answers
- 7654 Views
- I also Faced
- E-Mail Answers
Answer Posted / rupali
EARTH LEAKAGE CIRCUIT BREAKER WORKS IF IT GETS ANY CURRENTS
ACROSS EARTHING & IT DETECTS CURRENT THROUGH THIS OPERATION:
WE KNOW THE VECTOR SUM OF THREE PHASES IS EQUAL TO NEUTRAL &
EQUALS TO ZERO.IF EARTH DETECTS ANY CURRENTS THEN THROUGH
NEUTRAL FLOWS SOME AMOUNT OF CURRENT AND THE ELCB TRIPS OUT.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
what is the circutor?why we use it ?
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
what percent do you derate your copper wire when you change from copper buss to copper wire
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
What are the raitings of Mcb,mccb and Acb in detail ??
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
Define stepper motor. What is the use of stepper motor?
hi friends this is a newcomer in your community of enthusiastic peoples. i am preparing for SSC (CPWD JUNIOE ENGG EXAM FOR ELECTRICAL) pls guide me on the same how to crack it? PLS LET ME KNOW IS ANYONE THERE WHO PASED IT? CAN I GET THE QUESTION PAPERS OF PREVIOUS EXAMINATIONS?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
