Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / nikitha
It is the point where the bending moment changes its sign i.e from positive to negative.
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
What is dead load impact load live load
how to disign cuplock shuttering and it's matireal requirement snd any related web site
In jack arch floor, the rise is kept?
what is mean by c32/40s concrete class
how can i calculate cement in brickwork
how much area can be platered by a mason for exterior
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
Draw the cross section of a boundary wall and label its part with detailing?
what is pouring and explain
How many are the types of joints?
which red: used in roof teping, then use only cement
how many material required for brickbat water proofing of toilets.
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
Dear Sir What is the Contraction joint for base Slab
