Interested to Buy Any Domain ? << Click Here >> for more details...
A 6-pole, 50 Hz, 3-phase synchronous motor and on 8-pole,
50 Hz, 3-phase slip-ring induction motor are mechanically
coupled and operate on the same 3-phase, 50 Hz supply. If
they are left open-circuited, then the frequency of the
voltage produced across any two slip rings would be
- 2 Answers
- 5871 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / kannan
50 HZ
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
placement paper samples of mspl company
What is dynamo function in DG sets and draw block diagram?
what is load despatching
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
How can we increase fuel-power ratio of any DG set?
why they were using TRIAC instead relay in some controllers and what is the advantages.
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
List the disadvantages of constant k filters?
How to work definite,over pluxing,revers power,OSR relay
