Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mohammad
Earthing Switch is necessary to earth the conducting parts
before maintenance and also to provide deliberate
short-current while testing.This enables various tests to be
performed on the Switchgear or item of equipment, such as
testing the current Transformer of measuring the operating
time of breakers, without having to open the enclosure.
During normal operation the insulation is bypassed by a
short-circuit-proof link.
| Is This Answer Correct ? | 28 Yes | 7 No |
Post New Answer View All Answers
3phase motor can be used as a Prime mover for alternator.
how we calculate electrical load on a building according to area?
how to put cable sizing and cable glands size for respective cable & Cable Lug size in a DB sectors???
How to Calculate KA Rating of Main LT Panel
A Question Like A Wire Is Wound Whose Resistance Is Some 132. 44647 Ohms. If A Voltage Of 30 mv, 296 Ma Current Is Applied To It What Is The Resistance.
How to minimize the eddy current losses?
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
what is high - pot test. what's its use?????
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
Transformer diagram mention each parts ?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What happens if i apply 500V to 440V rotary Switch ?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How we can calculate the life of Lead acid battery
