what are the changes made in induction motor so that it act
as induction generator
- 4 Answers
- 5596 Views
- APPSC, I also Faced
- E-Mail Answers
Answer Posted / umdl
First of all a capacitor has to be connected parallel to the stator. Then Nr> NS.. that is you have to drive motor at a speed greater that its synchronous speed( Usually Nr must be about 50 rpm grater than Ns).
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
1.what is mean by 8/20 micro sec waveshape
impliment (AB)`+C to transistor representation
what is RNG in the DG synchronizing by PLC?
whether fibre optic cable in high voltage earth conductor is used for protection circuits
PLZ SEND ME SOME UNIQUE PROJECT OF ELECTRICAL ENG (B.TECH)
could you measure current in parallel?
i m in need of current rating chart of heavy duty pvc/xlpe, cu/al cables. can somebody provide me? if yes, plz send me at ashish_patel111@yahoo.com
How to convert 2 phase to 3 phase electricpower in induction moter?
how we decide the require size is this for a known current at fuu load?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is the significance of tan&delta and how it performed in power transformer
