Interested to Buy Any Domain ? << Click Here >> for more details...
in cable joints procedure what electrical problems have been
solved out ?
- 1 Answers
- 3631 Views
- I also Faced
- E-Mail Answers
Answer Posted / shaarau
insulation, surface n leakage current
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the selection process of breakers. Can any one please give a formulation on same?
What is “pu” in ee?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
Why saturation region slowly shifted in the left side?
how to select fuse rating for a 3-phase motor ???
Define sensitivity?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
What we mean by vintage of an engine+Generator?
WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.
draw the block diagram of fire alarm?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
