why cant we use mV instead of mA?
- 12 Answers
- 21053 Views
- ABB, Power Grid, Qatar Gas, USW, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / pankaj kumar (iert)
* voltage pickup more noise as compare to current.
* if we use voltage signal then chance of its drop.
*
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between mmwc and mmwg?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
Identification of control valve parts.
types of cable..? Use of every types of cable..?
How many interlocks at turbine? Plz explain briefly
Tell about your IFFCO plant visit.
what is output of FOUNDATION FIELD BUS transmitter
If P will increase then what will happen with PID?
why we are not using the turbine flow meter in the steam service?
Explain how thw analog to digital converter works with the circuit diagram
why orfice is not used for main steam flow calculation
How does your previous experience relate to the job you are applying for ?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
