How can ignition voltage of light increased with the help of
a ballast
Answer Posted / manikumar agcet
Normally gas filled tubes ie CFL
(carbon florocent lamp) have
negative resistance
characteristics ,hence at the
time of starting they takes
very high current
consequently voltage may
drop.Hence to reduce this
high starting current we
connect Ballast.Ballasts have
positive resistance
characteristics.hence it
balance the tube resistance.
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
define the non synchoronism of synchoronous machine in general g or m??
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
In motors how many types of cooling systems were used?
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
what is sevice settings for mccb?How can be it setted?
What is electrical cable termination
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
if i get a drop in my 1st year and the i clear my 2nd year and 3rd year all clear and i dont have any back logs so can i be able to sit in campus selection??
Explain difference between stand by earth fault and residual earth fault protection?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
What is the Nyquist criterion regarding control systems?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?