When we give supply to a transformer 11 kv and we get 415v
from it, so when we give supply to same transformer 415v on
ht side what we get?
and
When we gives supply to any transformer to L.T. side 415v or
220v What supply is on H.T. side?
Answer Posted / k.prakashchandra
The same ratio holds good.If you apply 415 volts on LT side
,the voltage on HT side would be 11KV.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
What is nichols chart?
what is the relationship between phase & neutral
during installation time of transformer and alternator which points we have to observed?
Define cuttoff frequency?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
how works inductive &capacitive sensors?
How many types of probe used in cro?
can i use 2000/5A Clamp meter to measure HT cable
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
How the frame size of a flange mounted AC induction motor is calculated?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA