Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of wave trap in an electrical substation?
- 2 Answers
- 15724 Views
- I also Faced
- E-Mail Answers
Answer Posted / subrata
Wave trap in electrical systems are used for power plant
communication through transmission wires.
It is a combination of low inductance in series and high
capacitance in parallel with transmission wires in power
frequencies. But communication signals are very low amplitude
and very high frequency signals. So, these signals are nearly
open circuited by the inductance and short circuited by the
capacitance.
That is how wave trap power and communication waves and used
in PPC.
| Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.
what is the significance of tan&delta and how it performed in power transformer
for opening electrical shop, tips needed.
how rectifier transformer work in electroststic precipetatore(esp?
how can tell us the AC indoor or outdoor which Tr and formulls
what is efficient motors and how it is different from normal induction motors
State thevenintheorem?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
What is use of starter and choke in tube light
list the advantages of RCCB over other circuit breakers?
What is Anemometer used to measure?
