Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / asad
IS 1786 will be used
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what is the composition of good brick ?
Define What are the reasons for geotechnical site investigations in Uganda?
Which ratio use for cement selery???
How to arrive dry volume of concrete (1.52 to 1.57) ?
can we make bricks using m10 grade cement concrete and what would be the ratio of raw materials used and price per brick ?
How to find coloumn vertical cut length floor to floor & lap + bend or anything plz clearfiy
What will be the exam pattern and syllabus for j.e post of haryana staff selection commision? Advt no. (02/2015) Some people says it would only be objective type question papers while others say it would be same as ssc (1 objective,1 conventional) ?? Please answer this question it is needfull to all.
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
what is the construction cost for per cft of multistorryed building in kolkata?
Doul Bar reinforcement and details of drawing.
How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
What is the standard rate of installing ties for column(60cmx60cm) and beams(50x850)(weight)
why do we not deduct volume of steel to find actual volume of concrete in practical???
how much cement and sand required for 100sqm of wall plastering in different proportions
