What is main cause of cable's terminal point burned in Lug
on high temperature although lug and cable selection is ok
as per stantard and also tightness is ok as per situation.
so please take in deep and tell correct answer thanku.
- 1 Answers
- 7428 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Bad crimping and insufficient contact area or lower 'lug
current rating'.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How npn and pnp transistor works
Name of the relay of low lub oil presuure in DG sets
Give accurate definitions for these electric terms: Inductor Inductance Inductive Induction Reactance Reactive Esam Baraka ٢١ ساعة
how to calculate the settings for shaft ct protn in hydro generators
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
What are the basic elements used for modeling mechanical translational system?
What is a compensator?
1hp= how much rpm
Operation carried out in thermal power stations?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
I am applying for NTPC examination.Can we please provide previous paper to my mail prasad.chintala108340@gmail.com
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
what is the standard duration after failure EB power
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
