If a generator of generating station produces 100MW rated
output then what will be the rating of the step-up transformer
connected to it?
- 5 Answers
- 5034 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
1250 MVA
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
Pl. brief about break-down maintenance of machine tool.
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
Why are the laminations insulated from each other?
can we use trip light with bus coupler?
percetans
how to calculate earth fault relay current and CBCT ratio
How the capacitance og capacitor volatage transformer is decided?
What is meant by impedance? difference between high & low impedance ?
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
