Answer Posted / mahmoud zaki
DO this is digital Output signal it is be Come from PLC or
DCS to machine Or motor for ex ; DI this is Digital Input
signal it is come from switchs(limit switch - proximity
Switch ) To System (PLC or DCS)
| Is This Answer Correct ? | 27 Yes | 4 No |
Post New Answer View All Answers
use of split range ? where it is used ? in which control loop it is used ?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
Difference between dcs and plc including date processing and architecture.
can any send me a forbes marshall dtron 316 manual
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
what is interlock system and why we use of this?
What are different types of orifice plates? State their uses.
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
How to calibrate capillary type level transmitter
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?